Say y here to include support for TI DaVinci DA850 based using Flattened Device Tree. More information at Documentation/devicetree
Configure this option to specify the whether the board used for development is a DM644x EVM
Say Y here to select the Lyrtech Small Form Factor Software Defined Radio (SFFSDR) board.
Configure this option to specify the whether the board used for development is a Neuros OSD2 Open Set Top Box.
Configure this option to specify the whether the board used for development is a DM355 EVM
Configure this option to specify the whether the board used for development is a DM355 Leopard board.
Configure this option to specify the whether the board used for development is a DM6467 EVM
Configure this option to specify whether the board used for development is a DM365 EVM
Say Y here to select the TI DA830/OMAP-L137/AM17x Evaluation Module.
The presence of UI card on the DA830/OMAP-L137/AM17x EVM is detected automatically based on successful probe of the I2C based GPIO expander on that board. This option selected in this menu has an effect only in case of a successful UI card detection.
Say Y here to use the LCD as a framebuffer or simple character display.
Say Y here to use the NAND flash. Do not forget to setup the switch correctly.
Say Y here to select the TI DA850/OMAP-L138/AM18x Evaluation Module.
The presence of User Interface (UI) card on the DA850/OMAP-L138/AM18x EVM is detected automatically based on successful probe of the I2C based GPIO expander on that card. This option selected in this menu has an effect only in case of a successful UI card detection.
Say Y if you do not want to enable any of the peripherals connected to TCA6416 expander on DA850/OMAP-L138/AM18x EVM UI card
Say Y if you want to use the RMII PHY on the DA850/OMAP-L138/AM18x EVM. This PHY is found on the UI daughter card that is supplied with the EVM. NOTE: Please take care while choosing this option, MII PHY will not be functional if RMII mode is selected.
Say Y if you want to use Video Port Interface (VPIF) on the DA850/OMAP-L138 EVM. The Video decoders/encoders are found on the UI daughter card that is supplied with the EVM.
Say Y here to select the Critical Link MityDSP-L138/MityARM-1808 System on Module. Information on this SoM may be found at https://www.mitydsp.com
Say Y here to select the TI AM1808 / OMAPL-138 Hawkboard platform .
Pin multiplexing support for DAVINCI boards. If your bootloader sets the multiplexing correctly, say N. Otherwise, or if unsure, say Y.
Makes the multiplexing functions print out a lot of debug info. This is useful if you want to find out the correct values of the multiplexing registers.
Choose Y here to warn whenever driver initialization logic needs to change the pin multiplexing setup. When there are no warnings printed, it's safe to deselect DAVINCI_MUX for your product.